Telephone: 086-755 86168952
Fax:086-755 86168953
Address:RM1507,15rd Floor,Bldg B,TANGSHANG building,No.35 guangshen Rd,Bao\\\'an District,Shenzhen,China.

Wafer Foundry

Current position:Home >ODM > Wafer Foundry

Wafer manufacture company put the electronic products design diaphragm in the conversion    on the multilayer mask by mask manufacturer. Then take silicon wafer as basic material,through IC wafer manufacturing process to put design of every layer mask in the conversionon wafer. There are hundreds to thousands of same IC tiny wafer on a wafer after the whole process finished.

Ⅰ.Small-lot production preparation

  1. Customer get designated technology design rules,PCM parameters and models from COMSIC wafer engineer department before production.
  2. Customer make boot and interface file, and set up database.
  3. CMOSIC wafer engineer department provide plate-making document ,framed data and deliver them to customer-designated photolithography manufacture .The manufacture make photolithgraphy based on customer database, plate-making document, framed data etc. (PS: CMOSIC do not contact customer’s database, intellectual property is protected ) 
  4. CMOSIC wafer production department verify photolithgraphy after it finished.
  5. CMOSIC wafer production department prepare tape out production as soon as  they take over the small-lot production document from wafer engineer department 

Ⅱ.Small-lot tape out production

CMOSIC wafer engineer department pay attention to tape out process,wafer production department ensure production process is going smooth.Wafer engineer department test PCM parameter , verify and analysis PCM results after tape out production is finished. After PCM parameter are validated, they will be delivered to customer by wafer market department. Mass production is allowed after confirmed by customer.



Contact

086-755 86168952

版权所有 Shenzhen intelligent co., LTD
备案号:粤ICP备10006787号-1
Add:RM1507,15rd Floor,Bldg B,TANGSHANG building,No.35 guangshen Rd,Bao\\\'an District,Shenzhen,China.